XTC-3D

Save time & energy with this brush-on coating for 3D printed parts. XTC-3D fills in 3D print striations and creates a smooth, high gloss finish. The need to post finish is almost eliminated.

• Size: 6.4oz (24oz available below).
• A very small amount of XTC-3D is needed to coat an average size 3D print.
• 28.3g (1oz) of mixed material will cover 651cm² applied at 0.4mm thickness.
• Two liquids are mixed together and brushed onto any 3D print.
• Coating self-levels and wets out uniformly without leaving brush strokes.
• Working time: 10 minutes
• Cure time: about 4 hours (depending on mass and temperature).
• Cures to a hard, impact resistant coating that can be sanded, primed and painted.
• Adding colours (So-strong pigments) and metal effects is easy.
• Does not contain VOC’s, phthalates or phosphates.
• Technical Data
• SDS

Coat any 3D Print Surface - XTC-3D can be applied to both SLA and SLS prints. It works with PLA, ABS, Laywoo, Powder Printed Parts and other rigid media.

It also can be used to coat EPS, EPDM and urethane foam as well as wood, plaster, fabric, cardboard and paper.

May be coloured using urethane pigments